44 discussions on Cabling-Design.com Forums about the Buffalo WHR-G54S: what owners asked, what went wrong, and what fixed it.
I want to set up one WHR-G54S attached to the cable modem via the WAN port. (this one, now DD-WRT)Then I want to use another WHR-G54S as a wireless access point where computers will be plugged into the LAN ports.Which Wireless Mode should...
I have a new Toshiba L35-S2171 laptop running XP Home. The built-in wireless shows up in Device Manager as an Atheros AR5005G. the driver version is 4.1.2.146. The router is a new Buffalo WHR-HP-G54, with firmware 1.40, using WPA TKIP...
Jeff Liebermann - since you seem to be the one in the know, I have a question for you, other may comment on this as well.I have DSL and a Buffalo WHR-G54S with DD-WRT v23 SP2 firmware, looking at this unit settings for wireless mode I see...
Bought one of these because I have a customer that has a long skinny building that he wants to add wifi to and I was hoping the better receiver and higher transmit power would offer him a little better coverage and from what I can tell it...
Since WRT54G firmware upgrade from 2.2 (I think) to V4.21.1 I no longer haveaccess to my laptop files no matter what I try. Internet access is OK,signal is very good, all firewalls have been turned off etc .. The OS is XPProfessional on...
I've been collecting factoids while getting my router flashed to DD-WRT. If there is a better site on the WHR-G54S, it would have been better to have found it before.