Cisco Systems

  1. Home
  2. Cisco Systems
14705 Threads Posts
to

Worth reading in Cisco Systems

IPSec Monitoring for ASA_Series over SNMP

Hi, we would like to monitor different Lan2Lan connections. We want to see the traffic on a per peer basis and we want...
2 comments posted 20yrs
posted by mail
2 comments posted 20yrs posted by mail

4006 PSU pin out

Hi I have a 400W PSU from a Cisco Catalyst 4006 and would like to know the pin out for the rear connector. In particula...
2 comments posted 20yrs
posted by colin.blount
2 comments posted 20yrs posted by colin.blount

Cisco 10/100 switch with 2 GB fiber and 2 GB copper

Hi friends, I just wanted to know if there is any Cisco 10/100 switch that can offer upto four gigabit ports (2 of them...
4 comments posted 20yrs
posted by gautamzone
4 comments posted 20yrs posted by gautamzone

A question in network design

I received a review question which I'm not sure about because something seems to be missing. 5 * Catalyst 2500 with 2 p...
4 comments posted 20yrs
posted by nhnmp
4 comments posted 20yrs posted by nhnmp

Cisco CSS.

Hi all, is there any useful book or site that gives informations on how to use CSS and what are its purposes? I already...
2 comments posted 20yrs
posted by am
2 comments posted 20yrs posted by am

Cisco 828 QoS

Well the question is Can "working" QoS or queuing work on a 828 router? As i havn't played with QoS much. I tryed place...
3 comments posted 20yrs
posted by bluefire_jack
3 comments posted 20yrs posted by bluefire_jack

Another ACL question

All, I have a core 6500 with a MSFC with multiple access/ distrubition switch. I will be installing a new switch for a...
2 comments posted 20yrs
posted by rich_grant35
2 comments posted 20yrs posted by rich_grant35

DF Bit

How do you turn off the DF bit before a packet goes out the default route on a 3550 G switch?
4 comments posted 20yrs
posted by towndummy
4 comments posted 20yrs posted by towndummy

Strange MPLS Connectivity Problem

All, I have been implementing an MPLS connection (1Mb link). The config on the serial end uses frame-relay encapsulatio...
1 comments posted 20yrs
posted by darrenfgreen
1 comments posted 20yrs posted by darrenfgreen

spurious DMZ

Confused by portions of the config file (see below). I set up this Pix, and serviced it yesterday, but dont have full r...
1 comments posted 20yrs
posted by arthur
1 comments posted 20yrs posted by arthur

Pix 501 - Site-to-Site VPN Tunnel

Hello NG I hav now tried multiply times to create a site to site vpn tunnel, between 2 cisco pix 501 firewalls I have t...
4 comments posted 20yrs
posted by SPAM
4 comments posted 20yrs posted by SPAM

Nested groups PIX.

hi all, PDM seems not to support nested groups (even if it displays them correctly). That was the question I posted on...
1 comments posted 20yrs
posted by am
1 comments posted 20yrs posted by am