Hi all,
I have four 2960 switches that have the same "problem" that is : their CPU couter is always at 20%.
Result of a "sh proc cpu | excl 0.00% 0.00% 0.00%" :
------------------------------- CPU utilization for five seconds: 20%/1%; one minute: 18%; five minutes: 18% PID Runtime(ms) Invoked uSecs 5Sec 1Min 5Min TTY Process 4 25706 7904 3252 0.00% 0.02% 0.00% 0 Check heaps 9 69647 393005 177 0.15% 0.13% 0.11% 0 ARP Input 15 11134 23296 477 0.15% 0.04% 0.01% 0 HC Counter Timer 23 4266 1774 2404 0.15% 0.03% 0.00% 0 Logger 28 12382 291453 42 0.00% 0.01% 0.00% 0 Net Input 29 26351 15572 1692 0.00% 0.02% 0.04% 0 Compute load avg 37 68213 4014589 16 0.00% 0.07% 0.11% 0 Fifo Error Detec 51 6369 2333729 2 0.00% 0.01% 0.00% 0 HLFM address ret 61 3079 34723 88 0.31% 0.07% 0.04% 0 hpm main process 64 15682 77252 202 0.00% 0.02% 0.02% 0 hpm counter proc 86 3299591 1775954 1857 13.09% 12.41% 12.20% 0 Hulc LED Process 90 29268 15554 1881 0.00% 0.04% 0.02% 0 HQM Stack Proces 129 12432 115997 107 0.00% 0.01% 0.04% 0 Spanning Tree 174 10288 32491 316 0.00% 0.02% 0.00% 0 IP SNMP 176 13856 16245 852 0.00% 0.01% 0.00% 0 SNMP ENGINE
-------------------------------
we notice that the process "Hulc LED Process" is getting most of the cpu time... strange....
I tried to change the display mode on the frontend of the switch (DUPLEX display instead of activity display) and this process stop getting cpu time... But, I can't let the display on "duplex mode" or "speed mode", after 30 seconds, the switch changes the display mode automaticaly to "activity mode".
I've done a lot of debug trace and network trace, and notice nothing special. But there must be something wrong....
I have several others switch (same 2960 with the same IOS), and no problem !?!
Is there someone with the same problem ? Is there a way to force the switch to stay in Duplex or speed display mode to avoid this ? Is this a known bug ?
Thanks in advance for your help.
H.
PS : Cisco IOS Software, C2960 Software (C2960-LANBASEK9-M), Version
12.2(37)SE1, RELEASE SOFTWARE (fc1)