Section 013 is no end of line. Zone attributes are all identical.
Zones 2, 5, 6, 7, 8 and 10 are stuck open (have shorted the zone on the panel to confirm it's closed)
Suggestions?
Section 013 is no end of line. Zone attributes are all identical.
Zones 2, 5, 6, 7, 8 and 10 are stuck open (have shorted the zone on the panel to confirm it's closed)
Suggestions?
Hello dgvollmer,
Excuse me while I have a weaker moment!!
Too little information to give a logical answer. But, as suggestions the following would be helpful.
What is the resistance on the wire??
How many switches on the loops??
Are the zones for doors windows, motions or other??
Why no E.O.L.??
What is your name and where are you located??
Answer the above just to get started.
Thanks,
Les
Have you tried throwing a resistor across the zone anyway to see if that changes anything?
Have you tried cycling power after making the programming changes, older DSC panels used to require that
Have you had a recent electrical storm?
Cabling-Design.com Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.