ademco vista 12D reporting

Not familiar with a Vista 12D in particular, but most the Ademco panels need to have the two-digit report code set to something other than 00 for the zone to generate reports. Perhaps try changing that for each zone that isn?t reporting?

Keith

According to the manual all sensors send whatever format is set in *48 including CSID, don't know what you mean by the other zones not reporting

i programm report code as 11 (BB) on any zone from 1 to 6 but it reports alarm only zone 4...

Should work fine programmed that way for any report code, its something else

not familiar with a vista 12D but each zone should be programed as something, (01-door,02-door, 03-permeter, 04-motion,etc...)

If there is still 00 in that slot then it will not report..

Then there should be a reporting code, (01 - 0E)

this site has the full programming manual if you don't have a copy...