I replaced a motion sensor that quit working and had to change the serial number.
I am not able to exit the program mode with the *99 . When I press the * it just
goes to the next field. What am I doing wrong??
Ademco Lynxr won't exit programming mode.
Nov 30, 2013
4 Replies
Did you exit *56 programming by inputting zone 00 (that exits zone programming) ??
No I didn't. I don't see anything in the books referring to that ??? So how do
I input zone 00 ??
OK, I finally found it in one of the books, and exited it. Now to test it all again..
Thanks.
Sure, no problem.
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required