Cisco Systems

  1. Home
  2. Cisco Systems
14705 Threads Posts
to

Worth reading in Cisco Systems

site-to-site vpn does not work

Hi, I have a PIX506E and a PIX515E, and set up a site-to-site VPN between them. But unfortunately for me, they do not w...
3 comments posted 21yrs
posted by bensonlei
3 comments posted 21yrs posted by bensonlei

pix 501 and vpn

When I try and set up a VPN thru the Pix 501 wizard, everything is ok until I click ok at the end. I then get an error...
0 comments posted 21yrs
posted by mwilliams
0 comments posted 21yrs posted by mwilliams

Port Block

Hello All I have been able to recover my 827H(corrupt ios- 15apr2005). The version of the IOS is newer than was previou...
0 comments posted 21yrs
posted by alainmartin
0 comments posted 21yrs posted by alainmartin

Port blockage

Hello all I was able to recover my 827H and now have it funtional and in operation
0 comments posted 21yrs
posted by alainmartin
0 comments posted 21yrs posted by alainmartin

VRRP between VPN Concentrators

I have 2 VPN Concentrators at 2 different geographic locations. Both these locations are connected with a P-to-P link a...
0 comments posted 21yrs
posted by ssaluja
0 comments posted 21yrs posted by ssaluja

Logging outbound traffic from PIX

I have syslog setup up and following configured on the pix: Cisco Secure PIX Firewall Version 5.3(1) logging on logging...
1 comments posted 21yrs
posted by ssaluja
1 comments posted 21yrs posted by ssaluja

Traffic shaping on the Cisco 2600 ......help!

I have a public facing Internet router on a 2Mb cicuit. I would like to restrict the amount of bandwidth used by SMTP o...
7 comments posted 21yrs
posted by mail
7 comments posted 21yrs posted by mail

Flow Inside-outside change only destination port

Hello everybody out there using Pixes I have a question regarding the change of destination port on PIX My intention is...
1 comments posted 21yrs
posted by eduardovazquez
1 comments posted 21yrs posted by eduardovazquez

PIX xlate Timeout or Logging?

I'm trying to track down some inside nodes that are running file sharing software. I'm currently getting a bunch of att...
3 comments posted 21yrs
posted by scott-i
3 comments posted 21yrs posted by scott-i

Rate-limits Cisco Router

Hi all I have a cisco router which uses rate-limits to control traffic inbound and outbound of each interface. The rout...
3 comments posted 21yrs
posted by c1tc
3 comments posted 21yrs posted by c1tc

Jam signal and collision detection

i figure that a jam signal would cause the receiving NIC to detect a bad CRC and reject the frame. but i'm wondering ab...
12 comments posted 21yrs
posted by jameshanley39
12 comments posted 21yrs posted by jameshanley39