Cisco Systems

  1. Home
  2. Cisco Systems
14705 Threads Posts
to

Worth reading in Cisco Systems

migrating to ATM DS3 with BGP

Hello, We just installed an ATM DS3 circuit with BGP with a the session up. Our current configuration is with a 4.5 pip...
1 comments posted 21yrs
posted by bnava
1 comments posted 21yrs posted by bnava

Cisco VPN issues

I'm actually not sure if this is a Cisco VPN issue, a D-Link issue, or a Dell issue. But I thought I'd start here. We i...
1 comments posted 21yrs
posted by nobody
1 comments posted 21yrs posted by nobody

Site 2 Site VPN support WINS?

Currently, I have Cisco 506e PIX and a Linksys VPN end-point router connected. I have NetBIOS Broadcast enabled on the...
7 comments posted 21yrs
posted by for_latest_news att hotmail do
7 comments posted 21yrs posted by for_latest_news att hotmail do

Ip NAT outside vs. IP route.

Just one question to who has already faced this problem. Imagine you have a router A with 2 interface on the Internet p...
3 comments posted 21yrs
posted by am
3 comments posted 21yrs posted by am

PIX 501 PPTP VPN RADIUS authentication problem

I am having a problem getting RADIUS authentication to work with a CISCO PIX 501 (version 6.3(4)). My network is config...
3 comments posted 21yrs
posted by eric.olsen
3 comments posted 21yrs posted by eric.olsen

Cat 2950 with no ip address

I have a switch at a remote location that has been in place for sometime that for some reason was never assigned an ip...
4 comments posted 21yrs
posted by rfield
4 comments posted 21yrs posted by rfield

3620 doesn't keep register value.

After reloaded my 3620 often shows me a register value different from default 0x2102 (sometimes 0x1). If I reboot it go...
3 comments posted 21yrs
posted by am
3 comments posted 21yrs posted by am

Monitor CPU and Memory Using SNMP

I have set up traffic monitoring using MRTG.I would also like to set up CPU and MEM monitoring using MRTG. I need to kn...
5 comments posted 21yrs
posted by alexm
5 comments posted 21yrs posted by alexm

Pix 506E IPsec site to site VPN Problem

Hello All, I am trying to set up two 506E Pix firewalls to use a Site to Site VPN. I can get that setup however afterwa...
4 comments posted 21yrs
posted by toldham
4 comments posted 21yrs posted by toldham

DataCenter Connections and best practices

We recently started leasing a cabinet in a data center with the idea that we would start keeping some of our mission cr...
0 comments posted 21yrs
posted by douglas
0 comments posted 21yrs posted by douglas

802.1Q Tunneling on two C6509 running CatOS 8.4(3)

I have setup an 802.1Q tunnel on two Catos 8.4(3) 6509 as follows: | WS-SUP720-BASE | | WS-SUP720-BASE | | WS-X6704-10g...
0 comments posted 21yrs
posted by arnold-200507
0 comments posted 21yrs posted by arnold-200507

cisco 800 series config

Hi, I have a cisco 800 series ADSL modem / switch, which is configured with the settings described below. This works fi...
1 comments posted 21yrs
posted by postmaster
1 comments posted 21yrs posted by postmaster

No ringback in VoIP call

I have an AS-5300 which receives calls though a POTS PRI and sends them out as VoIP to my SIP home phone (see config be...
1 comments posted 21yrs
posted by ramon
1 comments posted 21yrs posted by ramon