Cisco Systems

Compression to increase wan performance

Hello, I'm doing research if compression trough a router would improve performance on T1 point to point wan links. We a...

5 comments posted 18yrs

posted by sales

5 comments posted 18yrs posted by sales

Native VLAN mismatch on Cisco 2950

Little back ground: Currently we have a Cisco 3750 and a couple of Cisco 2950 switches. Only one VLAN on the whole netw...

8 comments posted 18yrs

posted by bavien

8 comments posted 18yrs posted by bavien

IPSec Tunnels set up, but can't pass traffic

I'm able to set up AES IPSec tunnels from an 1811 router to a 3845 router, but cannot pass traffic. A firewall, not und...

5 comments posted 18yrs

posted by masferfc

5 comments posted 18yrs posted by masferfc

Connecting via vpn

I am having some issues connecting to multiple networks/resolving dns. The setup that is in place. Office a: IP range:...

0 comments posted 18yrs

posted by leak73

0 comments posted 18yrs posted by leak73

SNMP MIB Object - <RTR> or <IP SLA>

Hello, my router has the following configuration: access-list 20 permit 10.10.10.10 snmp-server view Test mib-2.* inclu...

0 comments posted 18yrs

posted by c-schuetz

0 comments posted 18yrs posted by c-schuetz

qwest optical ethernet

Anyone have experience with this? im about to connect a few locations to a host location. The technology uses layer2 pa...

7 comments posted 18yrs

posted by coffin

7 comments posted 18yrs posted by coffin

who does session disconnects

I'm trying to have my ssh session disconnect after so many minutes of inactivity and while I was searching, seem to hav...

9 comments posted 18yrs

posted by ender

9 comments posted 18yrs posted by ender

Rapid STP in the WAN?

Scenario... 11 switches in a loop. Total distance of the loop is 200 miles (not sure that the distance matters...). Poi...

5 comments posted 18yrs

posted by wayne

5 comments posted 18yrs posted by wayne

Cisco 827 Voip

Hello, I have a Cisco 827-4V router. It has 4 voice ports but I could not find any kind of documentation on how to set...

4 comments posted 18yrs

posted by rj45

4 comments posted 18yrs posted by rj45

Cisco PIX Client VPN Config Problem

Hello All, I am trying to set up a client VPN on my PIX 515E. Everything seems to be going well on the client side unti...

0 comments posted 18yrs

posted by ben.paxton

0 comments posted 18yrs posted by ben.paxton

problem with cisco.com

Can anyone get to www.cisco.com today? They seem to be down. Doan

9 comments posted 18yrs

posted by doan

9 comments posted 18yrs posted by doan

PIX VPN Client Config Problem

Hello All, I am trying to set up a client VPN on my PIX 515E. Everything seems to be going well on the client side unti...

0 comments posted 18yrs

posted by ben.paxton

0 comments posted 18yrs posted by ben.paxton

Static Nat and VPN Issue

Hello, I setup an 1800 router at a client's site. I've configured a remote- access VPN for both remote administration a...

1 comments posted 18yrs

posted by tfskelly

1 comments posted 18yrs posted by tfskelly

Cisco 2950 and Huawei switch not talking over fibre

Hi all, hope someone can give some advice on here, cos we're stumped. Below is the e-mail that I've been sending to any...

0 comments posted 18yrs

posted by stewilliamson

0 comments posted 18yrs posted by stewilliamson

Cat-6506 Sup 720 and FWSM

Hi, I got one of my FWSM that will not boot. upon insertion i get the sho mod status of other and diags unknown. after...

3 comments posted 18yrs

posted by bilgravCUTTHISOUT

3 comments posted 18yrs posted by bilgravCUTTHISOUT