I am trying to upgrade the pix software on a 515E Failover unit. When I load version 7.2 it says that it completes the load and boots into
7.2 From there if I reload I get an error saying that there isn't an image in flash to boot. Also when I do dir flash: it shows the flash as empty. Once the copy completes I get the initializing flashfs message which I should get. Any ideas why my flash is empty?
what version you are upgrading from 6.x or 7.x ?
Roman Nakhmanson
starting to get the feeling there is something wrong with the hardware. The flash doesnt even seem to hold any image.
Hi David,
You may wish to investigate the June 16th, 2006 "thread," Pix fail-over questions:
Sincerely,
Brad Reese
David,
You may also wish to investigate Cisco PIX Hardware Troubleshooting:
Brad Reese Cisco Resumes
Cabling-Design.com Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.