hi all,
i got a problem after i config the 2610 and then 'wr mem' or even i try 'copy run start' to save teh config. but everything is reset when i reload it. hardware problem? memory problem? IOS problem?
pls advice, thanks.
paul
cisco 2610 config problem
Feb 19, 2006
3 Replies
Check the config register.
Doan
hi thanks for your reply. you are right. the config-reg is 0x2142. and it should be 0x2102 , right?
thanks paul Doan =E5=AF=AB=E9=81=93=EF=BC=9A
Yes, the 0x40 is causing the startup configuration in NVRAM to be ignored. Setting the configuration register to 0x2102 should solve your problem. Please look at
formatting link
for details about the bits in the configuration register.
Cisco da Gama
formatting link
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required