2600 cisco

Sam 18 years ago

Hi guys after loading a new IOS onto my 2610xm this is the message I got. the ios before did not work properly i guess and it kept saying nvram cannot write and that type of stuff. I figured if i instal a new ios it would fix the problem but even afterwards i get this message

00:04:43: %SYS-5-RELOAD: Reload requested by console.environment write to NVRAM failed

Warning: monitor nvram area is corrupt ... using default values C2600 platform with 65536 Kbytes of main memory

if anyone has any ideas I would apprecaite it. thanks

Vote

headsetadapter.com 18 years ago

Try to reboot your router with ignoring the config (boot into the ROMMonitor, change config register to 0x2142, and reboot), and then reformat NVRAM (do "write erase"). Then paste your config from the backup. Alternatively you may try to reboot your router using old IOS image (use TFTP IOS Recovery form the ROMMonitor).

Good luck,

Mike CCNP, CCDP, CCSP, Cisco Voice, MCSE W2K, MCSE+I, Security+, etc. CCIE R&S (in progress), CCIE Voice (in progress)

------ Headset Adapters for Cisco IP Phones

formatting link

Vote

Sam 18 years ago

Thank you for the response. I have tried that too and I still get that NVRAM message. Do you think its a hardware issue?

Vote

headsetadapter.com 18 years ago

Sam,

Have you tried the command "erase nvram:"?

Good luck,

Mike CCNP, CCDP, CCSP, Cisco Voice, MCSE W2K, MCSE+I, Security+, etc. CCIE R&S (in progress), CCIE Voice (in progress)

------ Headset Adapters for Cisco IP Phones

formatting link

Thank you for the response. I have tried that too and I still get that NVRAM message. Do you think its a hardware issue?

Vote

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required