Wizard IIe /Napco 1632

Have you configure the Wizard IIe as keypad #1?

I never had to do that on any panels. In fact becasue I liek to leave KP1 for programming on site I would never put the wizard on one.

I can think of a couple things. First off. There are two codes for a wizard. The wizard code, and then the user code you have programmed into the panel. You can set the wizard to use or not to use the wizard access code.

The other thing that comes to mind is whether or not you have assigned the wizard to an area. It assigns just like any other keypad.

Although to be honest the description of your problem doesn't seem to make any sense.

Bob, You're right about the keypad #01 assignment. I was remembering wrong. The limitation of using KP #01 only applies to enabling the client to use the Wizard IIe to change user codes. Doing so will prevent use of other keypads for that function.

I suspect the gentleman is simply entering an erroneous user code. It might be easier to correct the situation by defaulting the Wizard IIe and re-writing its program.

Ha ha ha ha ha ha ha ha Remembering wrong ...... HA HA HA HA HA HA

Translation: You don't know s*it about Napco products.

Suuuuurrrrrre ....... EVERYONE want's to use the Wizard to change codes..... yeh.......sureeeeeer they do!

Oh GREAT solution. After spending an hour to individually program, every letter of every word in every zone description, you suggest that he erase all that and start over again. GOOD JOB ............ you asshole.

The solution is in the difference between the access code and the user code.