- posted
16 years ago
Who makes this ugly ADT pir?
- Vote on answer
- posted
16 years ago
GE
- Vote on answer
- posted
16 years ago
works with the 5800 series receivers I assume?
thanks!
- Vote on answer
- posted
16 years ago
No, GE sensors don't work with Honeywell receivers, I've seen a hardwired motion that looks like that, you sure it's wireless?
- Vote on answer
- posted
16 years ago
Well...no, I didn't crawl above the ceiling tiles to check...just assumed that since they were too lazy to run 20 feet of wire to two doors (and put xmittrs there) that they did the same for the 2 pirs that are 15' in the other direction but easily prewired. 4 zones 2 are for sure wireless (the two doors) and 2 pirs...I'd have to go back and check tomorrow. It's definitely a Safewatch with a receiver though.
I was too lazy to climb up 15' to where they mounted the panel :-(
Thanks for the heads up...actually it's be nice if wired.
Rob
- Vote on answer
- posted
16 years ago
Here you go, scroll halfway down, it is hardwired.
- Vote on answer
- posted
16 years ago
Those kinda look like it..then I noticed the file name of the image I originally linked to: "v22_rf_motion.gif"
Maybe it's a wireless version, like they way the Sharpshooter comes wireless for different manufacturers??
- Vote on answer
- posted
16 years ago
This one?
- Vote on answer
- posted
16 years ago
I was looking again and GE does make an NX-482 that looks like that and is wireless
- Vote on answer
- posted
16 years ago
That sure looks like it...but I doubt it would work with Vista 5800 receiver or 6150RF keypad. Guess I gotta climb around again...which is a pain because it's doctor's office and I can only do it when there's no patients around.
- Vote on answer
- posted
16 years ago
If it is wireless no it won't work