Vista 20SE, 5882 question

You have to enroll each wireless transmitter, then assign it a zone type and other attributes. You'll need a 6139 keypad and the programming manual to do this. Good luck!

Thanks for the response.

I do have a keypad connected and the programming manual. I go to *56 to enroll the devices. I have programmed these devices before when my system was previously configured. My old system had hardwired devices , with an expansion box and the wireless receiver with wireless devices. I got rid of the expansion box and just want all wireless.

I thought I would start enrolling upto 16 devices at zone 10, but I can't seem to select zones 10 - 26.

The system only seems to see zones 01-09, 92, 95, 96 and 99.

I assume that I have the 5882 connected correctly, in parallel with the keypad and set to address 0.

I don't see anything else to do.

Frank Ols> > I did major renovations to my house which involved removing my entire

Check program field 22.

At least I think so, with that particular model.

rfalc> I did major renovations to my house which involved removing my entire

yep *22 should be set as 1

| > Is there something more to connecting up the 5882 on the 20Se ? | >

| > What should be the starting wireless zone offset ? | >

| > Any other information is greatly appreciated. | >

| > Thanks. | >

Hook your system to a phone line and find a technician that works (daily) with Ademco (Honeywell) to download a program into the panel. Have him print out the results and give you a copy. Honeywell sets a lot of defaults to let the panel work "out of the box" but unless you have a 6139 or 6160 keypad, the programming manual and some experience it will be error filled.