Concord 4 issue or user issue?

Effenpig1 · 2009-12-06T19:26:10+00:00

Had a customer call with a issue I've never come across before. Here'swhat happened: Installed a Concord 4 at her house about 3 months ago.I taught her to arm to stay with no delay at night, and then shechanges it to away when she leaves. Her daughter and son-in-law arevisiting, she left early in the morning and switched from stay toaway. After she left the daughter came out of her bedroom and trippedthe living room motion.Here's where it gets weird: Son-in-law calls me and tells me whathappened, he says he's concerned because "the alarm went off for about10 to 15 seconds and shut off by itself" ( Not just the siren stoppingbut a full clear)I checked the event logs and heres what I found:Zone 11 alarm then 5 seconds later an E406 cancel/abort by user #U846 ( master code)I'm thinking frazzled daughter gets crap scared out of her, panics,punches in code, then somehow forgets that she did it. Her and herhusband were the only ones there and he didn't even know the codeanyway, so I'm sure he didn't cancel the alarm. Also, there are nokeyfobs or wireless keypads/remotes, 2 hardwired ATP1000 keypads.I tested the system, arming it the same way they did that morning, noissues. I'm going to run it by GE tech support tomorrow morning. I'm99.999% sure it's just user error, but that .001% bugs me.So what do you think, is it user error? because I can't imagine whatelse it would be. Any thoughts?