Cisco Systems

  1. Home
  2. Cisco Systems
14705 Threads Posts
to

Worth reading in Cisco Systems

PIX NAT Type?

Can anyone tell me what NAT type implementation is used on a Cisco PIX? NAT implementation types as defined RFC 2663 Fu...
1 comments posted 21yrs
posted by
1 comments posted 21yrs posted by

Aironet 1200 firmware update problem

Hi, after a failed firmware update my Aironet 1200 Access Point comes up "empty" - with the minimal boot load that is....
2 comments posted 21yrs
posted by martin.bodenstedt
2 comments posted 21yrs posted by martin.bodenstedt

Multiple ISPs and Multiple IP Ranges from Each ISP

I have Multiple ISP Internet links and Multiple Valid IP ranges from Each ISPs.. I have configured to use both ISP line...
10 comments posted 21yrs
posted by chennak7
10 comments posted 21yrs posted by chennak7

nbar not working on Dialer interfaces ???

hi everybody, I have IOS 12.3(15) on a 2621 and I want to use nbar on my Dialer-If which connects to the DSL-modem of m...
1 comments posted 21yrs
posted by r.fiechtl
1 comments posted 21yrs posted by r.fiechtl

770 series ISDN router problem

I have the 771m ISDN router and have the following problem: There is no traffic coming from lan to wan. I cannot ping a...
1 comments posted 21yrs
posted by akaja_usunto
1 comments posted 21yrs posted by akaja_usunto

rate limiting an ethernet subinterface?

My telco is able to handle vlan tagging and dot1q encapsulation. They present their services via ethernet fibre or copp...
2 comments posted 21yrs
posted by D3xx
2 comments posted 21yrs posted by D3xx

PIX 501 to 2811 VPN

I have a basic VPN working between a PIX 501 and a 2811 router. However, I notice that devices behind the 2811 cannot i...
1 comments posted 21yrs
posted by gordon
1 comments posted 21yrs posted by gordon

reverse configuration change with power button

Hello, I am relatively new to cisco and I preatty much always do config t/ write mem for all my changes, I have a route...
3 comments posted 21yrs
posted by jcharth
3 comments posted 21yrs posted by jcharth

VLAN down

I have a 4-port switch on my 2811. I assign each port for a different vlan and it 's worked great until today when I di...
1 comments posted 21yrs
posted by dt1649651
1 comments posted 21yrs posted by dt1649651

Overload

We run a central pix with 20 or so 837 adsl vpn's of varying size coming back into this. The line is a 10mb line and we...
4 comments posted 21yrs
posted by no
4 comments posted 21yrs posted by no

Aironet 1100 going offline

I just got done upgrading the software in a Aironet 1100 access point. I've defaulted the confi and now after it resets...
2 comments posted 21yrs
posted by cmg2005
2 comments posted 21yrs posted by cmg2005