hi everybody,
I have IOS 12.3(15) on a 2621 and I want to use nbar on my Dialer-If which connects to the DSL-modem of my ISP.
The actual docu from Cisco states that nbar is supported on Dialer-If since
12.2(4)T.
But here at me it's not working. What have I done:
I activated nbar on the Dialer-If with "ip nbar protocol-discovery"
the I checked it with sh ip nbar protocol-discovery and got the following output:
router1#sh ip nbar protocol-discovery
Dialer1 Input Output Protocol Packet Count Packet Count Byte Count Byte Count 5 minute bit rate (bps) 5 minute bit rate (bps) ------------------------ ------------------------ ------------------------ bgp 0 0 0 0 0 0 citrix 0 0 0 0 0 0 .....
The are no values but there is traffic on the If. When I activate nbar on my internal fastethernet, it works.
What am I doing wrong.
Thanks in advance