Cisco Systems

  1. Home
  2. Cisco Systems
14705 Threads Posts
to

Worth reading in Cisco Systems

506e changing the internal IP address

Hi. I'm new to Cisco, so bear with me. I'm trying to change the internal IP address of a cisco 506e pix firewall. I als...
3 comments posted 20yrs
posted by pdrakos
3 comments posted 20yrs posted by pdrakos

501 and ssh

Hi all, I am using a Cisco PIX 501 OS is 6.3(5). I set it up to use ssh using the "ca generate rsa key 1024" command al...
2 comments posted 20yrs
posted by jamie
2 comments posted 20yrs posted by jamie

Edge BGP Router as Default Gateway

Ignoring capacity planning is it poor planning to have the edge BGP router as a default gateway for internal servers? G
6 comments posted 20yrs
posted by gshine
6 comments posted 20yrs posted by gshine

Cisco ATA186 lost password...

We have an ATA 186, and it appears a previous admin (who is no longer around) password protected it, and locked it out....
0 comments posted 20yrs
posted by jrcdehc
0 comments posted 20yrs posted by jrcdehc

Cisco Aironet 1490 wireless bridge and lightning

We have a Cisco Aironet 1490 Wireless Bridge located on one of our two way radio towers. It works excellently. However,...
0 comments posted 20yrs
posted by hrasmussen
0 comments posted 20yrs posted by hrasmussen

pppoe client in multiple context mode?

Hi, is it not possible to configure pppoe client in multiple context mode for pix 7.0?? None of the pppoe commands are a...
0 comments posted 20yrs
posted by nospam_cen
0 comments posted 20yrs posted by nospam_cen

blocking port 6346

The most common Gnutella port is 6346. Block this and you will stop 99% of traffic. but how can i block port 6346.. than...
3 comments posted 20yrs
posted by jariwalakrunal
3 comments posted 20yrs posted by jariwalakrunal

policy based routing

Hi Is it possible to route traffic from one interface only to routes that are advertised to the router with BGP protoco...
14 comments posted 20yrs
posted by eduke22
14 comments posted 20yrs posted by eduke22

6500 SSL module config synchronization possible?

Hi, is it possible to synchronize configuration between two SSL modules in 6500 switches? Content Switching Module has...
0 comments posted 20yrs
posted by m.mazurek
0 comments posted 20yrs posted by m.mazurek

l2pt

just shortly: if properly implemented [remote client on isdn, central office on dsl/cisco1721] is l2pt *secure*? is the...
1 comments posted 20yrs
posted by sali
1 comments posted 20yrs posted by sali

L2/L3/IPSec Testing Job Opportunities

snipped-for-privacy@zenaide.com has multiple job openings for Software test engineers with testing experience in routin...
0 comments posted 20yrs
posted by vaziraniv
0 comments posted 20yrs posted by vaziraniv

wireless client cannot communicate each other?

My client cannot communicate(e.g. ping) each other connected to the cisco AP... What's the command to allow it? thanks.
2 comments posted 20yrs
posted by louisjam
2 comments posted 20yrs posted by louisjam

Cisco 877W Router ( Newbie )

Hi, recently purchased a 877W router. New to IOS but thought this would be a good opportunity to learn. Originally was...
5 comments posted 20yrs
posted by n0mailplease
5 comments posted 20yrs posted by n0mailplease

BGP confederation path selection question

Hi all: Routing TCP/IP volumn2 and Internet Routing Architectures both said that EBGP routes is preferred over confeder...
0 comments posted 20yrs
posted by qch2012
0 comments posted 20yrs posted by qch2012