Cisco Systems

  1. Home
  2. Cisco Systems
14701 Threads Posts
to

Networking Question

Hi, I have a question on network optimization. I work at a company that has a corporate office. Our local division has...
5 comments posted 18yrs
posted by seijin
5 comments posted 18yrs posted by seijin

Replacing configurations with encrypted passwords

I recently had to apply a saved configuration to a 4500 series switch after replacing the supervisory engine (II+). I'v...
2 comments posted 18yrs
posted by pfisterfarm
2 comments posted 18yrs posted by pfisterfarm

Multicast/ MQC QoS policy issue

Hello, Here's a quick scenario: Router A has two WAN interfaces. One multicast receiver is served by each interface. If...
0 comments posted 18yrs
posted by no
0 comments posted 18yrs posted by no

as path

Is there a way to show the as path. I want to actually be able to see what as path the route has so I can better underst...
1 comments posted 18yrs
posted by gshine
1 comments posted 18yrs posted by gshine

Multilink Frame Relay - which IOS supports it

I need to set MFR on a router but the two IOS version I tried don't support the commands. I tried IP 12.3(23) and IP PLU...
4 comments posted 18yrs
posted by proulxsp
4 comments posted 18yrs posted by proulxsp

How to detect interface?

Hi, How to detect (via snmp - the best way) interfaces (on cisco catalyst switch) connected PC with enabled WakeOnLan? P...
2 comments posted 18yrs
posted by kesy
2 comments posted 18yrs posted by kesy

Secondary PIX keeps rebooting

hello we have a sateful failover configured on PIX 515E boxes, the scondary box had issues turining on and cisco had se...
0 comments posted 18yrs
posted by javzone
0 comments posted 18yrs posted by javzone

hsrp

Just wondering. Can you run hsrp between 2 routers when one router is on the local network and the other is the isp's ro...
6 comments posted 18yrs
posted by mmark751969
6 comments posted 18yrs posted by mmark751969

adding a switch to a switch stack

i am adding a switch to a 3750 switch stack that already has 2 switches in it. I am also running vtp in the network. I...
1 comments posted 18yrs
posted by mmark751969
1 comments posted 18yrs posted by mmark751969

Missing entries in Mac Address Table?

Hi, I'm studying for my CCNA exam, at some point I inadvertantly cleared all entries from the mac address table on my 2...
1 comments posted 18yrs
posted by SpamSpamSpam
1 comments posted 18yrs posted by SpamSpamSpam

Explicit FTPS (auth tls on 21) problems.

Hi, Well, I would like to be certain, that I'm not missing something obvious. I'm trying to let a FTPS explicit connexi...
0 comments posted 18yrs
posted by chemlecouscous
0 comments posted 18yrs posted by chemlecouscous

Upgrade 6509 from CATOs to IOS

All: I have a Cisco 6509 running CatOS. I would like upgrade to the newest IOS... Below is my configuration. Do I need...
4 comments posted 18yrs
posted by thomas.adams
4 comments posted 18yrs posted by thomas.adams

Cisco MDS NTP problem

MDS9216i# sh ntp peer-status Total peers : 1 * - selected for sync, + - peer mode(active), - - peer mode(passive), = -...
5 comments posted 18yrs
posted by joean.sian
5 comments posted 18yrs posted by joean.sian

NAT

All, If someone could point me in the right direction I'd appreciate it. Current setup is a 515E, two interfaces (outsi...
0 comments posted 18yrs
posted by jdougall
0 comments posted 18yrs posted by jdougall