Hi, how can i reset hardware factory defaults on a Cisco Catalyst 2930 without using a cable?
thanks
Reset Defaults on Catalyst 2950
Feb 16, 2006
6 Replies
You could enter the command:
"wr erase" and then do a reload
snipped-for-privacy@gmail.com wrote:
Thanks Jones...
But i can't telnet the switch because i don't know its ip.
byez
Hi,
so why don´t you connect via console cable ? ;-) There´s no other way to be at least connected to the switch with a console cable. Turn the switch off (Power cable) Turn it on while pressing for at least 5-10 secs the mode button. now a dialog should appear. now you have accesss to the file system and can delete the config file.
Mike
schrieb im Newsbeitrag news: snipped-for-privacy@o13g2000cwo.googlegroups.com...
Hi, Michael!
Because i don't have the blue cable. :)
Danke!
There is no way to break into a Cisco Router/Switch without the "Blue" (older ones are black) cable.
Hold in the mode button for 10 seconds and you will erase the config.
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required