How do I remove a trunk link?

Question

Call me stupid, but I cannot figure out how to get this removed from my config:

clear trunk 1/1 1-4094 set trunk 1/1 off dot1q clear trunk 1/2 1-4094 set trunk 1/2 auto dot1q clear trunk 1/3 1-4094 set trunk 1/3 auto dot1q clear trunk 1/4 1-4094 set trunk 1/4 auto dot1q clear trunk 1/5 1-4094 set trunk 1/5 auto dot1q clear trunk 1/6 1-4094 set trunk 1/6 auto dot1q clear trunk 1/7 1-4094 set trunk 1/7 auto dot1q clear trunk 1/8 1-4094 set trunk 1/8 auto dot1q clear trunk 1/9 1-4094

Those are ethernet ports that I just want to look like the other modules in the 6509.

#module 2 : 48-port 10/100/1000BaseT Ethernet set module name 2 CAT5-48-2 set vlan 130 2/1-48

Thanks in advance.

-Jason

CiscoHeadsetAdapter.com · Accepted Answer

Why don't you use the "set port host 2/1-48" command? Also, you can use "range" in your comands, for example "set trunk 1/1-9 off dot1q"?Mike

rebelangel151 · Answer

Hi Mike,I tried the "set port host" command, but I still see the set trunk andclear trunk stuff in my config...  I know I can use a range, but what Ineed to know is how to get rid of that stuff and basically put themodule back to a default state.Thanks for the help.-Jason

Arnold Nipper · Answer

On 15.12.2005 23:35      wroteTry something like  set trunk 1/1-48 1-4094same for dot1q.Basically you have to find out what the default is and just set the default. That will make go away additional config statements.But if it's only for cosmetic I wouldn't care. Why?Arnold

Newbie72 · Answer

I think it is set trunk mode off.... That will remove a port fromtrunking mode.Happy HolidaysSteven Johnson

Make · Answer

show config all (shows all default config +)clear config 1 (module number)

How do I remove a trunk link?

Join the Discussion

Didn't find your answer?