Need some help rather badly here :(
I've used the CRWS to reset my old 806 back to "factory" defaults but what on earth is the password it uses?
It's created a "Cisco" username on the thing but I can't seem to work out what password goes with it.
Any help greatly appreciated, getting a bit stressed here :(
Hi Toby,
Cisco 800 Series Routers, Field Notice: Extra Usernames and Passwords in Config after Using CRWS.
The CRWS telnet usernames/passwords are removed by issuing the command no username as shown in this example:
Router#configure terminal Enter configuration commands, one per line. End with CNTL/Z. Router(config)#no username srini
Password Recovery Procedure for the Cisco 806:
Brad Reese BradReese.Com Cisco Repair Service Experts
In article ,
Ta muchly :)
Have something to add? Share your thoughts — no account required.
Ask the community — no account required
