I would like to auto arm a panel. In case some on forgets to lock up. In the advanced section with the open and close times set and all the days selected. The words auto arm in slot 97 and arm after window checked. What else needs to take place for it to auto arm? I have seamed to have missed something. Rich
NX8 auto arm
Aug 02, 2008
6 Replies
The auto arming time???
Actually the term that is use is "Closing Time"
Just plug in a number and check the days. That should be it.
Oh and it needs to be READY to ARM in order to arm. Otherwise it won't.
Les
Oh I didn't check the arming days. I tried this before and the panel kept trying to arm in the day time.
I brought one home from the shop to try for the weekend.
I'd rather not confuse the OP. Stick with the terminology he's using if you can.
in "twenty four hour format"
The OP is (was) already confused. The manual says "Closing Time/Auto Arm Time". Since the OP most likely has not seen the term or program "Location Number" it may be easier to tell him what to look for.
Can the Closing time be extended if there's a user on site (working late?)
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required