I inherited a GE Caddx NX4 system not operational. Replaced the battery andinstalled new contacts on all doors. Everything was in order and looked fine.Then I got a code from the previous owner but as soon as I put the code in, thesystem armed and alarm went off. Now system is permanently armed, all the zones are flashing plus the servicelight is also flashing. The keypad does not respond. No code I try and submitresponds. Tried to disconnect the battery as well as the power for 48 hoursthinking it would clear the memory. Does not work. When I link the power and/or the battery the alarm sounds and all the aboveremain flashing. I disconnected the wires from the keypad in total. When reconnecting the statusquo remains the same.How do I do a factory reset? How do I clear the memory and start all over again.The keypad is a NX-124G*

As a special security code is required to do "installer programming", I was going to send the op a private email, but when I found that his email address is a long string of digits at I decided to decline. I went to and found that it is not a normal email service provider. John

how do I do a factory reset on GE Caddx NX4 security system (2025 Update)

Apr 19, 2015 Last reply: 1 year ago 22 Replies

Rate this thread:

Bob La Londe 1 year ago

WHAT DO YOU MEAN IT HAS WIRES? GASP!

Vote

RTS 1 year ago

haha, I can go with that. the new guys I know, always carry a tool box of nothing but batteries.. .. RTS

Vote

ABLE1 1 year ago

LOL I had a customer that said: Battery?? There is a battery in that thing??

Les

Vote

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required