FBI XL-2T Installation

I'm replacing my old panel and keypad (FBI-1218) with the XL-2T. I've connected all of the leads from the 4 zones but do not get a ready light, I have checked the continuity on each zone and I get tone on each. I did not connect the resistors to the leads as they were not connected on the old system. Is this the problem or is there something else? I tried programming the unit but still no ready light.


Reply to
Loading thread data ...

As i can remember by default the FBII XL2T zones are EOL so you have to install the resistors or to programm the zones as NC without EOL.

? ?????? ??? ?????? news: snipped-for-privacy@e9g2000prf.googlegroups.com...

Reply to
Proguard Security

Cabling-Design.com Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.