Factory Default for Napco 1016e?

I'm getting ready to replace an older Napco MA1016e with a newer Ademco Vista 15P panel. Before I remove the Napco, I'd like to set it back to factory defaults. Is there an easy way to do this (I have the installer code)? I can remove all of the values using Napco Quickloader software, but I'm hoping there is an even easier way to do it.

Lastly, what is the default installer code for these old Napco panels?

Thanks,

Rob Houston

Reply to
rahouston
Loading thread data ...

Okay, Jim, Thanks! What is the default installer code that I should restore for Napco?

Thanks again,

Rob

Reply to
rahouston

Nope...the easiest way is to use the software and download a clean file to it.

Jim Rojas

Reply to
Jim Rojas

Create a new "account" with the software. Don't enter any information in it. Download it to the panel.

It's been a while since I worked on a 1016e but ISTR it's 456789, same as several other Napco panels.

Reply to
Robert L Bass
456789

Jim Rojas

Reply to
Jim Rojas

Thanks, Robert. Creating a new "blank" account is an excellent idea!

Rob

Reply to
rahouston

No problem. Before you do it, make sure you know what the old settings are. It will save you some work reconstructing the program later.

Reply to
Robert L Bass

Cabling-Design.com Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.