Cisco Systems

  1. Home
  2. Cisco Systems
14705 Threads Posts
to

Worth reading in Cisco Systems

help needed with cable's

Hi, for lab purpose i want to connect two cisco 1601R routers thru the serial port. what for cable's are needed ? I have...
2 comments posted 21yrs
posted by mstrien#spam...
2 comments posted 21yrs posted by mstrien#spam...

Reverse telnet

I have a 2811 and a concentrator 3005. I connect the Cisco cable, the RJ-45 end to the aux port of the 2811, and the ot...
0 comments posted 21yrs
posted by dt1649651
0 comments posted 21yrs posted by dt1649651

Older version of IOS for 1100 AP

I'm looking for an older version 12.2(8) of the IOS for a cisco 1100 series AP. I wasn't able to find a copy on Cisco (...
1 comments posted 21yrs
posted by tcharsley
1 comments posted 21yrs posted by tcharsley

Cisco 675 - worth selling?

I have a Cisco 675 I'm not using, with power pack. Is it even worth trying to sell anymore? I see some listed on ebay fo...
3 comments posted 21yrs
posted by LakewoodChess
3 comments posted 21yrs posted by LakewoodChess

Cisco ip igmp proxy-service

Hi Group I have enabled ip igmp proxy-service on Cisco 837 so I can receive multicast streams from my adsl provider ip...
0 comments posted 21yrs
posted by carl
0 comments posted 21yrs posted by carl

Telnet into a udp port

Hi, is this possible? have a problem with a user connecting tcp over a network to a NATted IP address.. but saying his...
2 comments posted 21yrs
posted by antzj
2 comments posted 21yrs posted by antzj

What's the need of PIX (when there's IOS FW)?

Hi, can any security experts here enlighten why is there a need to use PIX when routers with IOS FW provide firewall an...
3 comments posted 21yrs
posted by remove_anti_spam
3 comments posted 21yrs posted by remove_anti_spam

router->wireless bridge->router problem

Hi to all, I'm having troubles by connecting two routers via a wireless link. There is a 2610 connected to an AP352 na...
1 comments posted 21yrs
posted by mike
1 comments posted 21yrs posted by mike

Serial number inside.

Hi all, I though serial number reprted on the rear of 837 was the same reported as Processor Board ID doing "sh ver" I...
4 comments posted 21yrs
posted by am
4 comments posted 21yrs posted by am

Cisco 1760 boot: cannot load "flash:"

Hi On a Cisco 1760, i have loaded the startup-config, away ftp, of an other working Cisco 1760. After such operation ha...
1 comments posted 21yrs
posted by utentetecnico
1 comments posted 21yrs posted by utentetecnico

Access from dmz to inside (dumb question)

Hi all! I try to make static translation from dmz network to inside (PIX 515 with 3 ifaces) as described here...
2 comments posted 21yrs
posted by d_frost
2 comments posted 21yrs posted by d_frost

cant get commands under "router eigrp #" to work?

I'm trying add the following commands to my router and its not liking the commands under the "router eigrp 2" command....
2 comments posted 21yrs
posted by scott-i
2 comments posted 21yrs posted by scott-i