cant get commands under "router eigrp #" to work?

I'm trying add the following commands to my router and its not liking the commands under the "router eigrp 2" command.

router eigrp 2 network default-metric 1000 100 255 1 1500 no auto-summary

I get the Following: donner.sf-ts(config)# router eigrp 2 donner.sf-ts(config)# network ^ % Invalid input detected at '^' marker. (it points to the 'w' in network)

Works fine on my 11.2 router.... Any Ideas

Here is the "Show Version" on my router...

Cisco Internetwork Operating System Software IOS (tm) 2500 Software (C2500-IK8OS-L), Version 12.2(13), RELEASE SOFTWARE (fc1) Copyright (c) 1986-2002 by cisco Systems, Inc. Compiled Tue 19-Nov-02 21:07 by pwade Image text-base: 0x0306FD38, data-base: 0x00001000

ROM: System Bootstrap, Version 5.2(8a), RELEASE SOFTWARE BOOTLDR: 3000 Bootstrap Software (IGS-RXBOOT), Version 10.2(8a), RELEASE SOFTWA)

donner.sf-ts uptime is 1 hour, 29 minutes System returned to ROM by reload System image file is "flash:c2500-ik8os-l.122-13.bin"

cisco 2500 (68030) processor (revision L) with 14336K/2048K bytes of memory. Processor board ID 02053789, with hardware revision 00000000 Bridging software. X.25 software, Version 3.0.0.

2 Ethernet/IEEE 802.3 interface(s) 2 Serial network interface(s) 32K bytes of non-volatile configuration memory. 16384K bytes of processor board System flash (Read ONLY)

Configuration register is 0x2102

Reply to
Scott Townsend
Loading thread data ...

Once you start eigrp with the "router eigrp 2" command, the prompt should change to config-rtr. Since it's not doing that, I'm guessing routing is not enabled on that router, look for "no ip routing" "ip routing" should fix you.


Scott Townsend wrote:

Reply to
David West

Ah... bliss...

Thank you!

Not sure why routing was turned off. It is a Dual Ethernet and was last routing between DSL, local LAN and a Serial Link... Maybe since I was using NAT I had it off.

Thanks again, Scott Once you start eigrp with the "router eigrp 2" command, the prompt should

Reply to
Scott Townsend Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.