Cisco Systems

  1. Home
  2. Cisco Systems
14705 Threads Posts
to

Worth reading in Cisco Systems

E1 and BRI VWICs on same router??

HI There, running a 1760 CCME to PSTN via Bri (IOS 12.3(14)T5) Just got an E1 VIC to do a trunk to a mitel PBX (3300) u...
0 comments posted 20yrs
posted by peter.rowe
0 comments posted 20yrs posted by peter.rowe

Cisco 3750, 2960, and SFP's OH MY!!

Hi All, I have a question about SFP's at 100Mbs. I want to connect multiple 2960's to the Cisco WS-C3750-24FS-S (24 100...
1 comments posted 20yrs
posted by jawill8301
1 comments posted 20yrs posted by jawill8301

Allowing icomming connections?

I am suspecting that one of my users is allowing an Internet IP Addy into my network. I see many of the below lines (PI...
3 comments posted 20yrs
posted by wil
3 comments posted 20yrs posted by wil

11503 Config Question

I have inherited a 11503 Content Switch and I am trying to understand its configuration In its present configuration int...
3 comments posted 20yrs
posted by Dhahn
3 comments posted 20yrs posted by Dhahn

Thoughts on PIX v7 cont...

ORIGINAL-- Currently running 6.3(4) on 525 FO configuration. Tested conversion on 515 with a copy of our live config -...
1 comments posted 20yrs
posted by ricosuave.info
1 comments posted 20yrs posted by ricosuave.info

Broadcast forwarding to ISDN PRI

We use a Cisco 2621 and a NM-2CE1B (double ISDN PRI). 60 customers can dial in, each using one B-channel. Is it possibl...
0 comments posted 20yrs
posted by sleeman
0 comments posted 20yrs posted by sleeman

E1 problem

Hi there, I have 2821 + E1 WIC + PVDM2-8 Module. Is it enough to configure E1 as an ISDN PRI? thanks, Paul
2 comments posted 20yrs
posted by fronti27
2 comments posted 20yrs posted by fronti27

CallManager call delay

I have a CallManager 4.0.1. I created a route patter 9.@ using NANP. When I dial a local number 456-7890, there is a 10...
3 comments posted 20yrs
posted by supernet
3 comments posted 20yrs posted by supernet

Queue Drops

I have Internet connections in two different sites from the same ISP. This ISP uses Frame Relay for their Internet conn...
6 comments posted 20yrs
posted by vincent.aniello
6 comments posted 20yrs posted by vincent.aniello

Ethernet over ac power lines

I though I had seen a ethernet over ac power adapter. Two units that you plug into any outlet and then you plug your eth...
5 comments posted 20yrs
posted by njkat
5 comments posted 20yrs posted by njkat

PIX 704 Connat pass traffix

I have been testing the new PIX v7.04 software on a 515E and ran into something I cannot understand.. On v6.3.5 I can r...
1 comments posted 20yrs
posted by kilbyfan
1 comments posted 20yrs posted by kilbyfan

subnets in access lists...

I want to block any ip starting with 61 from accessing any one of 17 ips on my network. I know the following should wor...
5 comments posted 20yrs
posted by captain99_1999
5 comments posted 20yrs posted by captain99_1999

IDS & Spoofing -- PIX 6.3(4)

What commands need to be configured to enable the IDS & anti spoofing on the PIX 6.3(4) ? I think I have it setup corre...
1 comments posted 20yrs
posted by just1coder
1 comments posted 20yrs posted by just1coder

vpn redundancy PIX and 3000 series

Is it possible to have pix501 firewalls and 3002hw clients setup so they can vpn into a pix525 firewall, and if the int...
5 comments posted 20yrs
posted by jerodbunch
5 comments posted 20yrs posted by jerodbunch