Cisco Systems

IPSec VPN Cisco 1812 and ASA 5510

Hi, I set up IPSec VPN between Cisco 1812 and ASA 5510. Tunnel works fine, ping from PC to internal interface of the ro...

2 comments posted 17yrs

posted by no

2 comments posted 17yrs posted by no

"no ip classless" and "ip cef"

Hi All, Does anyone have any idea if "no ip classless" still works in recent IOSes? I have observed on Cisco 2801 that...

9 comments posted 17yrs

posted by pawel

9 comments posted 17yrs posted by pawel

two radius validation

I have Pix with a connection ipsec for my clients of Cisco VPN. The validation in by Radius IAS and one vpngroup. Who I...

3 comments posted 17yrs

posted by amperis

3 comments posted 17yrs posted by amperis

show interfaces trunk cmd missing

I have a couple of old switches, 2900 and 3500 series (IOS 12.0(5).WC5 and 12.0(5)WC7) Configuring trunking on these is...

5 comments posted 17yrs

posted by tdenham735

5 comments posted 17yrs posted by tdenham735

Need recommendation on firewall and vpn replacement

We've got a pair of PIX 525s in active/standby mode, plus a pair of VPN 3005 concentrators (one active, one redundant u...

4 comments posted 17yrs

posted by pfisterfarm

4 comments posted 17yrs posted by pfisterfarm

3750 load balancing over dual links with seperated VLAN's

Hi, I'm trying to setup a system which uses 2 transparent networks as WAN. All "routers" are Cisco 3750 and each locati...

2 comments posted 17yrs

posted by marcrietman

2 comments posted 17yrs posted by marcrietman

Nu0 interface

Hi, I should start out by saying that I am not a Cisco expert by any stretch so if I state the obvious in the post, ple...

3 comments posted 17yrs

posted by charlescorps

3 comments posted 17yrs posted by charlescorps

Hairpin VPN not responding

Recently I have created an hairpin VPN using a ASA 5510 (8.0(4)28) as a hub and Cisco 877 (12.4(4)T8) as the spokes. Th...

0 comments posted 17yrs

posted by ikkemij

0 comments posted 17yrs posted by ikkemij

Wired dot1x failure

Hi, I'm doing some testing with wired dot1x and coming across possible future support issues. The supplicants are XP ma...

2 comments posted 17yrs

posted by bob

2 comments posted 17yrs posted by bob

Same Network on Two Interfaces

Hello, This is a general network question, not hardware specific, related to PC's, Unix/Linux or routers... I know that...

7 comments posted 17yrs

posted by tdenham735

7 comments posted 17yrs posted by tdenham735

Cisco 5505 VPN interface not pingable

Hi, It's been a long long time that I haven't touch a PIX or ASA appliance, and I'm very very rusty. I just bought a Ci...

1 comments posted 17yrs

posted by cpdivers

1 comments posted 17yrs posted by cpdivers

Up->Down messages related to ip sla icmp-echo when there are no apparent network issues

I am trying to use ip sla with icmp-echo to control the entry of a static route in the routing table. Currently I am us...

3 comments posted 17yrs

posted by ttripp

3 comments posted 17yrs posted by ttripp

VOIP Call Routing

I have an ivr system which listens on port sip 5060 port on lan. Is it possible to setup voip call routing on pix 501 to...

0 comments posted 17yrs

posted by nobody

0 comments posted 17yrs posted by nobody

snmp-server ifindex persist on ASA 5510

Hi There is similar command on Cisco ASA 5510 ? after any reboot OID are changed...:( thx for info regards W

0 comments posted 17yrs

posted by walde-nospam

0 comments posted 17yrs posted by walde-nospam

EasyVPN with only one address in the pool

Can I have only one IP address in ip local pool? Or at least static address assigned to the client? My client is Cisco r...

2 comments posted 17yrs

posted by igor.mamuzicMAKNI_OVO

2 comments posted 17yrs posted by igor.mamuzicMAKNI_OVO