Cisco Systems

  1. Home
  2. Cisco Systems
14701 Threads Posts
to

Worth reading in Cisco Systems

Confusing VPN issue with 506e

Hello, I am attempting to set up a site-to-site VPN between two 506e devices. The issue I have is that the tunnel negot...
2 comments posted 19yrs
posted by jason.turcotte
2 comments posted 19yrs posted by jason.turcotte

building a home network around a cisco 1003 router

Greetings everyone, I am somewhat inexperienced with routers,but I have collected masses of Cisco resource material,hav...
5 comments posted 19yrs
posted by encinomaan
5 comments posted 19yrs posted by encinomaan

cisco 3500 series XL

hi, i only have one ip address ... how can i make route between two vlan ? i'am lost !
4 comments posted 19yrs
posted by pfe
4 comments posted 19yrs posted by pfe

1800 router series

Hi Does anyone know if the 1800 routers' Ethernet switch module ports can be configured for routing ports? Thanks. Al
7 comments posted 19yrs
posted by nomail
7 comments posted 19yrs posted by nomail

Inside to Inside NAT

I'm trying to configure my c837 to use inside-to-inside NAT, but I'm not getting anywhere, and everywhere I've looked o...
2 comments posted 19yrs
posted by mail
2 comments posted 19yrs posted by mail

Cisco 2611 NAT Configuration

Hey guys. My company is changing suites at the end of the month. I am pruning alot of the old and non needed gear out o...
1 comments posted 19yrs
posted by jetter2
1 comments posted 19yrs posted by jetter2

Cisco 3694 configuratioin.

Scenario: I receive my internet via a cable modem. This is plugged into the Cisco 3640 eth 0/0. ip is dhcp'd. My intern...
3 comments posted 19yrs
posted by frank.mogavero
3 comments posted 19yrs posted by frank.mogavero

Help with DHCP Snooping...

Hi, I am about to make the following setup: Internet | | ---------- Firebox ---------- | ---------- |- |HP ProCurve 265...
5 comments posted 19yrs
posted by thomas [at] elmer-hartmann.dk
5 comments posted 19yrs posted by thomas [at] elmer-hartmann.dk

Number of IKE Tunnels and IPSec Tunnels

The number of IPSec tunnels we have is always > the number of IKE tunnels. In terms of the number of "IPSEC Tunnels" li...
1 comments posted 19yrs
posted by masferfc
1 comments posted 19yrs posted by masferfc

IP Routing Question on 3560 Switches

Hi, I have a network with two Cisco Catalyst 3560 switches ( standard image ) and am trying to setup routing between VL...
4 comments posted 19yrs
posted by nospam
4 comments posted 19yrs posted by nospam

Port forwarding problem with ASA 7.2

Hello there, I ran onto a funny issue with ASA. I'm trying to make port forwarding where my NAT inside global address i...
0 comments posted 19yrs
posted by pseto
0 comments posted 19yrs posted by pseto

How to configure 3DES on Cisco 2801 Router

Hi, I am new to networking field and can some one please tell me how to implement 3DES on 2801 router. By default all t...
1 comments posted 19yrs
posted by thepul
1 comments posted 19yrs posted by thepul

boot system command

The boot system commands only work when the config register is set to 0x2102 correct? Thank y'all, Ciscopimpenator
1 comments posted 19yrs
posted by ciscopimpenator
1 comments posted 19yrs posted by ciscopimpenator

How do I calculate Percentage Bandwidth Utilization?

Hi All, I have the following information from Cisco IP Accounting logs and need to calculate percentage bandwidth on th...
2 comments posted 19yrs
posted by ishaam.hendricks
2 comments posted 19yrs posted by ishaam.hendricks

S.O.S

Hi guys, Can I upgrade the aironet ap 1231G (AIR-AP1231G-A-K9) into a LWAP to work with WLC 2106 (AIR-WLC2106-K9)? If no...
4 comments posted 19yrs
posted by dandashi
4 comments posted 19yrs posted by dandashi