Cisco Systems

Migration OSPF -> EIGRP

Hi group, for a customer I should plan the migration from ospf -> eigrp What is the best practice.. Should I run on all...

7 comments posted 18yrs

posted by ukonstantin

7 comments posted 18yrs posted by ukonstantin

Pix 501 VPN IPsec Configuration

My goal is to allow outside users to establish vpn connection using cisco vpn client vs. 4.*. I used pdm to make this c...

1 comments posted 18yrs

posted by nobody

1 comments posted 18yrs posted by nobody

DHCP client implementation

DHCP client RFC says for DHCPREQUEST packet in INIT-REBOOT state "requested IP address option MUST be filled in with cl...

0 comments posted 18yrs

posted by santa19992000

0 comments posted 18yrs posted by santa19992000

New Cisco ASA 5505 Appliance Help?

Hello, I'm trying to setup a Cisco 5505 to tunnel to a LinkSys VPN router, but not having much luck. I'd like to do IPS...

0 comments posted 18yrs

posted by tdenham735

0 comments posted 18yrs posted by tdenham735

Block MAC-Address on a 2851 Router?

Hello, is it possible to block a given MAC-address on a 2851 router (IOS 12.4)? If so, how? Regards, Christoph Gartmann

1 comments posted 18yrs

posted by gartmann

1 comments posted 18yrs posted by gartmann

Cisco ASA IPSEC Tunnelling

Hello, I am trying to engineer a solution that will meet our needs. I've come into a network, and am having to figure i...

1 comments posted 18yrs

posted by jimsu1973

1 comments posted 18yrs posted by jimsu1973

Pix 501 VPN and PPPoe

The outside interface is connected to dsl modem and PPPoe connection has been configured on Pix 501. Can this pix firewa...

4 comments posted 18yrs

posted by rgelfand2

4 comments posted 18yrs posted by rgelfand2

Starting for CCNP

I'm curently an CCNA and I am thinking about starting to learn for CCNP. Which one of the four exams would you recommend...

7 comments posted 18yrs

posted by notimportant

7 comments posted 18yrs posted by notimportant

prevent unauthorized dhcp

iIf I deny using switch policies the source udp port 67 except for the official dhcp server port no unauthorized dhcp se...

3 comments posted 18yrs

posted by bsch13

3 comments posted 18yrs posted by bsch13

Number of active users on 3825

Hi, I am using MRTG to monitor the interface traffic and cpu util. of my 3825 which acts as a gateway to internet. Is t...

2 comments posted 18yrs

posted by sanalkisi

2 comments posted 18yrs posted by sanalkisi

vpn routing override

Hi all, I have a setup with 2 ISP's, and a default out one of them. I have two client vpn crypto maps created and appli...

0 comments posted 18yrs

posted by info

0 comments posted 18yrs posted by info

Load Balance with Cisco ISR 1801

Hi everyone, I'm trying to load balance with a Cisco 1801 using port Fe0 and the built-in ADSL modem port (ATM). Both c...

1 comments posted 18yrs

posted by iambigfish

1 comments posted 18yrs posted by iambigfish

Content Filtering revisited

Hi all, In one of my last posts we were discussing about different free content filtering solutions for a pix 506e. The...

2 comments posted 18yrs

posted by handley88

2 comments posted 18yrs posted by handley88

Point to Point T1

Hello: I am trying to bridge to locations via a point to point t1. The provider says that they do no provide clocking o...

8 comments posted 18yrs

posted by someone

8 comments posted 18yrs posted by someone

PIX - I deny everything ! (an inside job)

This worked fine on my PIX 501 Version 6.3(5) access-list acl_in deny tcp host 192.168.0.16 any eq 80 access-group acl_...

1 comments posted 18yrs

posted by support

1 comments posted 18yrs posted by support