Cisco Systems

vtp client failing to update

What would be the main reason for vtp client failing to update? It has the right domain name and a lower revision numbe...

4 comments posted 18yrs

posted by pfisterfarm

4 comments posted 18yrs posted by pfisterfarm

flow/packet loss through L3 C3560, pings OK

I have a Catalyst 3560G that is doing L3 routing. I tried to use it as default gateway for a web cluster, which was doi...

3 comments posted 18yrs

posted by Phil.Begriffenfeldt

3 comments posted 18yrs posted by Phil.Begriffenfeldt

ASA 5510 and NAT to Site-to-Site

I have a site to site VPN set up. Going forward I would like to take the outside interface IP that is encrypted inside...

1 comments posted 18yrs

posted by rkovelman

1 comments posted 18yrs posted by rkovelman

CallManager config backup

Hi all: I need to backup the CallManager config and restore it into a new CallManager. Can I use the Disaster Recovery...

0 comments posted 18yrs

posted by xianli2

0 comments posted 18yrs posted by xianli2

1751 flash memory discrepancy question

I have a 1751 showing it has 16M of flash memory, ie. 16384K bytes of processor board System flash (Read/Write). Multip...

3 comments posted 18yrs

posted by DonGLong

3 comments posted 18yrs posted by DonGLong

GLBP Check

I have setup GLBP to replace HSRP on my two host routers. However, they do not appear to be load balancing when I look...

2 comments posted 18yrs

posted by russianj

2 comments posted 18yrs posted by russianj

Policy Based Routing on Cisco L3 Switch 3550 with IOS 12.1(22)

Hi all, I have a 3550 L3 switch and I am trying to implement policy based routing. My setup is as follows: PC1 | | | Sw...

2 comments posted 18yrs

posted by bernala

2 comments posted 18yrs posted by bernala

SMTP and tcp ports

I have an access list applied inbound on the outside interface of a 2600 connected to the edge router. I found that I n...

19 comments posted 18yrs

posted by nobody

19 comments posted 18yrs posted by nobody

Policy based routing

Hi all, I have a 3550 L3 switch and I am trying to implement policy based routing. My setup is as follows: Firewall 1 -...

0 comments posted 18yrs

posted by bernala

0 comments posted 18yrs posted by bernala

cisco vpnclient for cmd script

hello I have a couple of scripts to automatically connect with the cisco vpnclient one is a vbs script, the other is a...

2 comments posted 18yrs

posted by jcharth

2 comments posted 18yrs posted by jcharth

A QoS dscp question

For DSCP, Which one has higher priority AF1 and AF4? My answer is AF4. but same book give AF2 for web traffic and AF4 fo...

9 comments posted 18yrs

posted by aaabbb16

9 comments posted 18yrs posted by aaabbb16

How to use CLI to change pre-shared-key on ASA: Forgot Password

Hello, I've forgotten the pre-shared-key needed to connect via VPN. How do I change it via the CLI. I entered the follo...

4 comments posted 18yrs

posted by buck

4 comments posted 18yrs posted by buck

ATM QoS on 877

Hi, I'm having a bit of trouble in getting the full bandwith on an IPoATM connecion ( ADSL w/ LLC encapsulation) I've s...

9 comments posted 18yrs

posted by mafonso

9 comments posted 18yrs posted by mafonso

IP SLA and HSRP - Please help

Hello I would like to achieve redundancy but I was not able to understend completely the topic: I read this: http://tcp...

4 comments posted 18yrs

posted by admin

4 comments posted 18yrs posted by admin

Feature set codes IOS file images?

Hi, does any know where to find a list of the feature set codes for router IOS file names? I have searched high and low...

4 comments posted 18yrs

posted by john.heitmuller

4 comments posted 18yrs posted by john.heitmuller