I am not able to ping across my serial line. Here is what I hope is the information that is needed. I am logged into my console port. This is a

2501 router running 12.0. I have configured the e0 interface with address The serial interface is configured with a point to point setup and addressing is as follows: s0 = s1 = I have ip routing "on". I have configured a static route to to e0. When I ping the simulated serial line, it fails. When I ping my ethernet connection, it works no problem. This all occurs from the console port, not a telnet. Can someone help?

Thanks, Neal

Reply to
Loading thread data ...

I didn't think IOS would let you configure two interfaces in the same subnet.

Reply to
Barry Margolin Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.