Hello, I'm encountering the following problem on my Cisco 7206 ... In order to do load sharing between my 8 E1 interface I've configured 8 static routes. But if I do a sh ip route x.x.x.x ... I can only see 6 routes instead of 8. I'm doing the same on the router in the other side and I'm able to see the 8 routes. Any idea ? Michel
Michael, as far as I know, cisco load-shares traffic only across a maximum of 6 equal paths by default. For dynamic routing-protocols like RIP there is a command ("maximum-paths") to specify a different number. However I dont know if this can be changed for static routes...
Regards, Axel
Michel DUBOIS wrote:
Cabling-Design.com Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.