I was looking at the doc's for the Linksys WAP54GP AP. It can have up to 7 wireless vlans but it must be connected to a managed switch to have more than 1 vlan. What to you need (switch wise) to do this?? It really doesn't say or point you in any direction. As far as I can see the AP only has 1 lan port, so how is the managed switch connected?? I'm sure I'm missing something...
Thanks
Can't set vlans or a trunk on an unmanged switch!
Does it matter the model of the switch??? Do you need to configure the switch differently??
Thanks
Mfr of the switch probably doesn't matter as long as it supports the standards. Of course you would need to configure the switch, the switch would need to trunk, then you would need something to route the vlans if it's not an L3 switch.
Have something to add? Share your thoughts — no account required.
Ask the community — no account required