How can I get it into rommon mode and get it's old firmware back into the flash??
Thanks
Ivan
How can I get it into rommon mode and get it's old firmware back into the flash??
Thanks
Ivan
Hi Ivan,
You may wish to investigate ROMmon Recovery for the Cisco 2600 Series Router:
Brad Reese Cisco IOS Software - Compatible Partner Matrix by Technology
Send a serial break within 30 seconds of poweron while booting. issue the tftpdwnld command (to see what variables need to be set, then set them appropriately) and TFTP the new IOS image down to the router.
It will take you at least 30 minutes to put an boot images ios to the rom.
We buy sell all Cisco, Discount up to 80% off on New Used Cisco. LinkWaves Corp
29980 Technology Drive, Suite 6 Murrieta, CA 92563Ivan82 wrote:
Cabling-Design.com Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.