new cisco1721 router i start hyperterminal and power on router
i configured FastEthernet0 interface with ip 192.168.1.10 and sub
255.255.255.0 and enebled fullduplexhow i configure WIC0 and WIC1 also ethernet cards Ethernet0 and Ethernet1 interface??? what command line should i type?
tnx in advance
newbiee
interface ethernet0 ip address x.x.x.x y.y.y.y no shut
interface ethernet1 ip address x.x.x.x y.y.y.y no shut
The wics are just physical slots or cards, all you need to do is do 'interface ' and configure whatever kind of cards you installed. Unless I'm missing something obvious.
Cabling-Design.com Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.