Cisco 2615XM router with SDM 2.4.1 I'm trying to get PC's on a LAN to access a default gateway adsl router so they can surf the internet but I'm stuck at the Cisco 2615XM router Here is my setup: small LAN of PC's all connected by cables to a hub, all ip's set on 192.168.1.xx Cisco 2615XM router also connected to the hub on Fastethernet port 0/1, set as as192.168.1.70, set as LAN Cisco 2651XM Fastethernet port 0/0, DHCP set port to 192.168.1.64 set as WAN, connected by cable to Cisco wireless access point (configured as a universal workgroup bridge). The Cisco access point ip is 192.168.1.66 and it is connected wirelessly to a non-cisco adsl router on the internet (default gateway 192.168.1.254).
I'm trying to get the PC's on the LAN to access the default gateway router so they can surf the internet but I'm stuck at the 2615XM router. The PC can see both FastEthernet ports but I can't get the PC to see the Cisco access point on 192.168.1.66. In SDM/Interfaces and Connections I did Test Connection but the test fails at Checking Exit Interface, the recommended actions say: 'Select User-Specified option or add host specific/network specific/default route through this interface and retest connection'. I'm not sure where I'm supposed to go in SDM to do this, I've tried different things but fail to create the route so if anyone can help me put the right settings into SDM that'd be great. Thanks for any help.