Incorrect bandwith for QOS using SDM?

Cisco amateur here...I have 2 1841's which I want to set up QOS for VOIP. I'm using the SDM to do this but when I set the interface as Serial0/0/0 and go through the QOS wizard, on the bandwidth percent section it's showing the % allocation for a total of 100000kbps. We only have a single T1...where/how do I change this total bandwidth so it knows to use 33% of 1500kbps instead of 100000kpbs in SDM?

Reply to
Loading thread data ... Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.