SX200 / 2000 AAN Question

Hi...

The main site SX2000 (lw29 q40) location has 2 pris, the SX200 (lw 19.3) remote location has 1. The two switches are connected by a T1 tie line. One of the pris at the main site is flat rate. I can send local calls from the

200 over the tie line, but the outbound caller ID shows the default CPN number.

Will AAN allow me to send the callers extension number from the 200 to the

2000 which in turn would be sent out correctly on the pri? Or, is there a better way to accomplish this?

Thanks in advance Dave

Reply to
Henry Cabot Henhouse III
Loading thread data ...

Cabling-Design.com Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.