whats good to use to mask off an area on a motion sensor?
masking
Dec 19, 2007
9 Replies
A wall does a pretty good job.
A dirty old sock with a hole in it.
So you met my ex mother in law?
I use white electrical tape. I trim it to the right size with a decent pair of scissors.
I also find that if you apply it to the *inside* of the lens it doesn't look bad at all.
RW: I usually wait till Halloween to mask all my motion detectors.
You should start earlier. Some of them are pretty ugly.
I like the Nixon mask ....my self.
Kind of gives that message Ooooooow ..... I am not a crook!
white-out (correction fluid, whatever you want to call it)on the inside of the lens
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required