In Wall Switch

I don't think so. The switches are just standard non-X10 switches. Only one of the MicroModules even transmits X-10 and I think you'd have to use it with no lighting load if you merely wanted to generate an X-10 signal for the system controller.

I th>I was looking at the In Wall Switches from Marmitec and have a few

Yes. The LWM1 will transmit its state whenever it is turned off or on via the switch.

I th>Dave Houston skrev:

Dave Houston skrev:

Thanks for your help Dave.

What I really would like is to connect a switch (pulse) to some kind of module that can generate a X-10 signal for the system controller.

At the same time I would like some kind of module that holds a on/off or dimmer function for the lamp.

At best Both of the above in one box. Or as an alternative in two boxes.

Anyone with an idea on what's on the market that can do this for me?

Regards Claus

Dave Houston skrev:

Some of the modules I mentioned have to-way X-10 transmission. From what you write is sounds as if I should only expect a status signal telling the system controller whether the switch is on or off.

Did I understand you correct on this one?

Regards Claus

Dave Houston skrev:

Then it's beginning to get cramped behind the switch with two modules :(

So... to replace a double switch for a chandelier I would need 4 modules...... I'm beginning to loose faith in this X-10 system :(

Regards Claus