Attempting to Access WatchGaurd Firebox II to re-configure

Just recently dusted off this old firewall appliance and was tasked with getting it going. When attempting to access the firebox in "Enahnced System Mode" via x-over cable on two interfaces and connecting via TCP/IP to the trusted ethernet port the system does not go into Enhanced System Mode nor does the SysA light flash.

Does anyone know of a method of accessing this firewall to bring it back to operational.

Thanks in advnace.


I used the method descibed in this post:

formatting link

Reply to
Loading thread data ... Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.