Cisco Systems

Cisco 4402, Web Authentication function without requiring logins

Hi all-- I'm attempting to configure the web authentication function on a Cisco 4402 Wireless LAN controller. Once a mo...

1 comments posted 17yrs

posted by tyndareus

1 comments posted 17yrs posted by tyndareus

need help with redirecting port 80 traffic

I've been working on this for awhile now, but have bad no progress. I have a small regional Wifi network, the field uni...

5 comments posted 17yrs

posted by john

5 comments posted 17yrs posted by john

Cisco Catalyst Express 520 VLAN solution for shared office

Scenario: New client (Acme) has relocated and is sharing an office with Bacme. The wish to keep their networks separate...

0 comments posted 17yrs

posted by david.powerbits

0 comments posted 17yrs posted by david.powerbits

full-duplex mode on NM-1E1R2W

Hello, i want to use the above network module (one ethernet, one token ring) in a 3640 for a 10mbit leased line with fu...

9 comments posted 17yrs

posted by karstenf

9 comments posted 17yrs posted by karstenf

physical interfaces on ASA5520

My ASA5520 has 4 GE NIC, and one FE NIC/MGMT. Right now of my four GE NICs, I have outside, inside, dmz, and the fourth...

1 comments posted 17yrs

posted by john

1 comments posted 17yrs posted by john

Setting up "MS File Sharing" on PIX515E 7.2 using ASDM 5.2

I finally have my Pix configured, and have learned much about how it works, however I still have a problem with seeing...

6 comments posted 17yrs

posted by dhenzler

6 comments posted 17yrs posted by dhenzler

Shutting down ASA 5505 tunnel

For testing purposes, I want to shut down an IPSEC tunnel in an ASA 5505 appliance after it was automatically establish...

2 comments posted 17yrs

posted by ns_dkerber

2 comments posted 17yrs posted by ns_dkerber

bgp configuration

Is there a command to get ebgp-multihop & update-source configuration other than: show run | section bgp User doesn't ha...

1 comments posted 17yrs

posted by umesh.agashe

1 comments posted 17yrs posted by umesh.agashe

Does LCP count towards ATM interface counters?

Have a problem with an 1841 with 2x DSL WIC, where the second WIC won't re-log in without a reboot, ie it will drop per...

9 comments posted 17yrs

posted by troffasky

9 comments posted 17yrs posted by troffasky

MPLS load balancing with P2P DS3s

We have three core sites that are each connected via point-to-point DS3s, (triangle design) using OSPF. We also have an...

6 comments posted 17yrs

posted by ciscoboy67

6 comments posted 17yrs posted by ciscoboy67

Question concerning STP

Hi there! I have some basic questions concerning STP. I had a big network issue today since to the fact that the networ...

5 comments posted 17yrs

posted by anhecgn

5 comments posted 17yrs posted by anhecgn

Filter traffic by MAC Address : Cisco 2960/3750 Switches

Hi, Is it possible to configure Cisco 2960/3750 switches to filter traffic based on allowable MAC addresses only? Examp...

1 comments posted 17yrs

posted by russell

1 comments posted 17yrs posted by russell

basic ACL help pls

I need some basic IOS ACL help. We have the following config: version 12.3 service timestamps debug uptime service time...

4 comments posted 17yrs

posted by see_footer

4 comments posted 17yrs posted by see_footer

Backup Routing Problem

Hello NG I'm an Newbee with Routing and i have an Question about using Backup- Route Following Problem : 2 Locations, c...

2 comments posted 17yrs

posted by peter.blumenau

2 comments posted 17yrs posted by peter.blumenau

asynchronous link vs synchronous link

Hi Folks, Can somebody please explain the basic differences between a synchronous/asynchronous link? Thanks, syuga

2 comments posted 17yrs

posted by syuga2012

2 comments posted 17yrs posted by syuga2012