Cisco Systems

Need some help setting up ATM LANE

I've got an ATM network consisting of an 8510 switch at the central site, connecting to about a dozen remote sites, mos...

0 comments posted 18yrs

posted by pfisterfarm

0 comments posted 18yrs posted by pfisterfarm

DHCP Client issue in 2960 switch

I have a ciso 1841 router as a DHCP server. It has the following pool ip dhcp pool switch host 192.50.201.50 255.255.25...

1 comments posted 18yrs

posted by mgpprasa

1 comments posted 18yrs posted by mgpprasa

ISP connection with ISDN 1721 router

Hi, I'm trying to connect to my ISP using ac 1721 cisco with ISDN WIC. I tryed differents config but nothing worked ! I...

3 comments posted 18yrs

posted by ph-arjona

3 comments posted 18yrs posted by ph-arjona

nat problem

Hello ! I want to do address translation on a cisco 1600. (IOS (tm) 1600 Software (C1600-Y-M), Version 12.0(9)) ip pack...

13 comments posted 18yrs

posted by lpopoz

13 comments posted 18yrs posted by lpopoz

Cisco 2950T-24 not linking to ethernet devices

Hello I have a strange problem. I have a C3620 with a NM-4E module and a Cisco 2950T-24 switch. If I connect a port of...

5 comments posted 18yrs

posted by admin

5 comments posted 18yrs posted by admin

Cisco IPS dropping packets

I am trying to setup the cisco IPS on the front facing interface of a 3845 router. Every time I enable the IPS, no pack...

7 comments posted 18yrs

posted by BarrySDCA

7 comments posted 18yrs posted by BarrySDCA

ASA as VPN Endpoint

Is it possible to configure the Cisco ASA5510 (running 7.2(2) software) to simultaneously support remote PC users using...

5 comments posted 18yrs

posted by bavien

5 comments posted 18yrs posted by bavien

Using Dialer Watch to Failover

I'm hoping the experts here can help me with a problem that's been plaguing me for a couple of days. We have a Cisco 28...

1 comments posted 18yrs

posted by shinobi2

1 comments posted 18yrs posted by shinobi2

IPSec VPN with c2600 router

Hello, I have a Cisco 2621 router, and I would like to use it for my office VPN access. I configured it with pptp and i...

7 comments posted 18yrs

posted by rj45

7 comments posted 18yrs posted by rj45

Dinosaurs won't route

You guys, I hate having to ask something so simple, but I"m stuck. I was away from the old Cisco access routers for a c...

4 comments posted 18yrs

posted by bob

4 comments posted 18yrs posted by bob

Looking for int's? 1MFT T1, VIC 2FXS, WIC 1DSU, WIC 1T link's inside!

They're all from my lab... They work. Each auction is no-reserve starting at 1 penny! Thanks. Goodluck. 1MFT T1...

1 comments posted 18yrs

posted by joey024

1 comments posted 18yrs posted by joey024

Load Balancing 2 T1s with 2 routers

I have two 3845 routers with IOS version 12.4(2)T1. The T1s are connected to a private MPLS cloud used by my company fo...

7 comments posted 18yrs

posted by russianj

7 comments posted 18yrs posted by russianj

Pix Debug Commands

Hello Guys, I want to monitor ICMP traffic only going out of a high sec zone to a low sec zone. I am trying to figure o...

10 comments posted 18yrs

posted by g3tsmarter

10 comments posted 18yrs posted by g3tsmarter

site to site ipsec without public ip at one end

I have a remote LAN which locates inside another company. I would like to set up so that the headquarter LAN can access...

4 comments posted 18yrs

posted by dt1649651

4 comments posted 18yrs posted by dt1649651

ASA 5505 Configuration Problems

I am trying to configure an ASA 5505 to allow Remote Desktop Protocol from outside to a host on the inside network. I c...

8 comments posted 18yrs

posted by naves.tom

8 comments posted 18yrs posted by naves.tom