1. Home
  2. Cisco Systems
  3. Upgrading Firewall Version and PDM on PIX 506E (newbie user)

Upgrading Firewall Version and PDM on PIX 506E (newbie user)

This is its show version:

Cisco PIX Firewall Version 6.1(2) Cisco PIX Device Manager Version 1.1(2)

Compiled on Fri 16-Nov-01 14:28 by morlee

Hardware: PIX-506E, 32 MB RAM, CPU Pentium II 299 MHz Flash E28F640J3 @ 0x300, 8MB BIOS Flash AM29F400B @ 0xfffd8000, 32KB

0: ethernet0: address is 0009.b718.b578, irq 10 1: ethernet1: address is 0009.b718.b579, irq 11

Licensed Features: Failover: Disabled VPN-DES: Enabled VPN-3DES: Disabled Maximum Interfaces: 2 Cut-through Proxy: Enabled Guards: Enabled Websense: Enabled Inside Hosts: Unlimited Throughput: Unlimited ISAKMP peers: Unlimited

I would like to upgrade to Firewall Version 6.3(4) and PDM 3.0(2) but I don't know if this PIX needs some else requeriment. I have .bin files but I don't know if these are what I need or need more. They are pdm-302.bin and pix634.bin.

I have instructions to upgrade PDM but I don't know how to upgrade firewall version.

Any response will be appreciated.

THANKS!

Reply to
jaisol
Loading thread data ...

In article , jaisol wrote: :Cisco PIX Firewall Version 6.1(2) :Cisco PIX Device Manager Version 1.1(2)

:Hardware: PIX-506E, 32 MB RAM, CPU Pentium II 299 MHz

:I would like to upgrade to Firewall Version 6.3(4) and PDM 3.0(2) but I :don't know if this PIX needs some else requeriment.

No, your 506E should be able to handle 6.3(4) without difficulty.

:I have .bin files but I don't know if these are what I need or need :more. They are pdm-302.bin and pix634.bin.

Those are what you need.

:I have instructions to upgrade PDM but I don't know how to upgrade :firewall version.

formatting link

Reply to
Walter Roberson

Cabling-Design.com Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.