Cisco 525 and PDM

Hi gents, I've always managed little cisco pixes and now i have to manage a 525. First of all I noticed that telnet was the way to connect, I used to connect with ssh. Is there any advantage or problem to change this ? I feel more secure with ssh

I also noticed PDM isn't enabled, I know it's for security issues, but it would help for disabling access-lists easier . Is there any disadvantage enabling the pdm in the 525?

what lines are necessary to configure pdm access ? is this enough?

http server enable http inside

Hope you can help me thanks in advance.

Reply to
Loading thread data ...

Are you sure you're using a 525 and not a 520? If you have a 520, you might have a 2mb flash card that won't hold the PDM images. Try running 'show version' and see what it says. If it reads something like 'Flash E28F128J3 @ 0xfff00000, 16MB' then you've enough room to install it. You can 'ls flash:' to see what files are there currently. You may also be running a pre-PDM version of Finesse. Posting some more details will help us to better help you with your issue.


Reply to

It's a 525 for sure, I think that it doesn't have pdm and ssh active.

Hardware: PIX-525, 256 MB RAM, CPU Pentium III 600 MHz Flash E28F128J3 @ 0x300, 16MB BIOS Flash AM29F400B @ 0xfffd8000, 32KB

Is it possible pdm ?

Gary ha escrito:

Reply to
Sako Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.