Is there a Step-By-Step guide to upgrading an IOS image on a Catalyst 2950 switch?
I have the switch, i have a laptop, i have a later version IOS image.
how do i get it onto the switch.? I assume TFTP ? but how? Do i delete the old IOS off .. or just overwrite it over the top?
Does it save the config, or do i need to re-write it on?
If it breaks half way through - is there a "recovery procedure".
I'm just used to doing firmware updates via web-interfaces ... why do Cisco make it so hard
Soooo many questions! :)
Thanks! Bob.